1 / 4
Yaesu SMAJ to SMA antenna adapter sleeve — zdjęcie 1
1 / 4

Yaesu SMAJ to SMA antenna adapter sleeve

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Graduating from a Baofeng BF-F8 (UV-5R variant), to a Yaesu FT-1XD, I was faced with repurchasing quality antennas for…

Ocena
0 / 5
Polubienia
23
Pobrania
134
Wydruki
0
Wyświetlenia
891
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Graduating from a Baofeng BF-F8 (UV-5R variant), to a Yaesu FT-1XD, I was faced with repurchasing quality antennas for it. With this adapter and a Male-Male SMA adapter, you can use the SMA-Female (often refered to as "J" style) antennas designed for the Baofeng on the Yaesu. I suspect this will work with most other Yaesu radios as well, but have not tested any. Feel free to customize as you see fit.

Tip: print just a 5mm height section to test-fit until you have the extrusionSquish parameter dialed in for your printer.

Print instructions

Category: Electronics Summary

Graduating from a Baofeng BF-F8 (UV-5R variant), to a Yaesu FT-1XD, I was faced with repurchasing quality antennas for it. With this adapter and a Male-Male SMA adapter, you can use the SMA-Female (often refered to as "J" style) antennas designed for the Baofeng on the Yaesu. I suspect this will work with most other Yaesu radios as well, but have not tested any. Feel free to customize as you see fit.

Tip: print just a 5mm height section to test-fit until you have the extrusionSquish parameter dialed in for your printer.

Print Settings

Printer Brand: Printrbot

Printer: Simple White

Rafts: Doesn't Matter

Supports: Doesn't Matter

Resolution: 200 microns

Infill: 100%

Notes:

Set to 10 shells so all paths are concentric

Tagi