1 / 2
Miniature Wind Turbine Blades
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wind turbine blades for small motors
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 493
- Makes
- 1
- Views
- 1,391
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Engineering
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These are wind turbine blades designed to be used with small motors with 2 mm shafts.
Specifications
- Hub Radius: 12.5 mm
- Shaft Hole Radius: 2.15 mm (should fit 2 mm shafts nicely)
- Blade Length: 73.95 mm (excluding hub)
- Blade Width: 23.83 mm (start) and 10.96 mm (end)
Print Instructions
- Temperature: 200 °C (low temperatures prevents sagging and fusing with supports)
- Layer Height: 0.1 mm (other layer heights should be fine)
- Filament: PLA (tested with PolyLite Black PLA)
- Supports: Under the blades (preferably PrusaSlicer snug supports)
Included g-code is for Original Prusa i3 MK3S and MK3S+ ONLY. The included 3MF file has all the print settings already configured. Expect prints to be very rough on the bottom unless soluble supports are used. Note that even though the screenshots show grid supports, snug supports are used in the actual print files.