ESP8266 Node Mcu Print in Place Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
ESP8266 print in place case with hinge to keep your ESP board safe covered in you IOT projects.
- Rating
- 5 / 5
- Likes
- 28
- Downloads
- 193
- Makes
- 1
- Views
- 1,929
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
I was fiddling around with fully printable hinges and created this design for a project. There is a small gap of 0.2mm between the top and bottom parts. After printing you may need to carefully crack possible connections between both parts to make the hinge fully functional.
I removed the pinheaders for the ESP8266 board and soldered wires to it. The small channel (close to the hinge) may be used to guide the wires to any periperhals outside the case.
Required hardware:
- 6x 1.7mm x 5 self tapping countersunk screws
Printing Instructions
- Prusament PETG Urban Grey
- layer height 0.15mm
- No support
- No raft
Feedback Appreciated
Please give feedback and post your makes. Any suggestions and improvements are appreciated.