Spot Light Honeycomb Filter
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.56 – €0.68 net (excluding VAT)
For file: Honeycomb Filter.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.62 excluding VAT (range midpoint).
- Weight reported by the author
- 3 g
- Print time reported by the author
- 51 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This honeycomb filter drops inside a spotlight to make the light more directional.
- Rating
- 5 / 5
- Likes
- 38
- Downloads
- 312
- Makes
- 2
- Views
- 1,397
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
This honeycomb filter drops inside a spotlight to make the light more directional.
The model has been designed for the Ikea NYMÅNE Ceiling Spotlight. Measure the size needed and scale the model to fit.
The biggest tip I can give you is, print the initial layer as slowly as possible. I was doing it at 5mm/s or 20% of the Ender 3 V2 default speed. If you leave it at full speed, it will likely not print properly. The attached file should contain all the correct settings when opening in Cura.