Gridfinity 1x2x4 hex punch holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Gridfinity hex punch storage for ten punches. Punches are held at a 30 degree angle to lower profile.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 19
- Makes
- 0
- Views
- 212
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Public Domain
This is a remixed Gridfinity tool holder for 10 hex base metal pin punches (e.g. 9 pc Pin Punch Set (princessauto.com)). The hex dimension is 3/8", but the hole hex is 10.45 mm, which allows approximately 1mm clearance for each punch.
I suggest printing a test piece first to ensure the hex holes provide enough clearance for your tools: I have included a 3mm high test model that should print in about five minutes using the settings below.
I also altered the magnet holes in the base, so that they print a little cleaner without supports.
The remix was done on Tinkercad, and can be seen / copied / remixed using this link: https://www.tinkercad.com/things/cUfzSaCyp9y?sharecode=YmIOCHaTNztS8WKd5AIX2nrJtvQdbfu-PRJcXNrvC9U
I printed this using PLA on an Ender 3v2 with an 8mm nozzle, at 200 degrees C, with a bed at 50 degrees. Layer height was 0.32mm (draft quality), 20% cubic infill, no supports, with print speed at 50mm per second.