1 / 2
Thermistor Antenna
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- GNU General Public License v3.0
BOM:
- SHCM3x30mm [1x]
- M3 Voron heat-set insert [1x]
Compatibility:
- Voron ClockWork2 Extruder;
- CW2 style mounts for other extruders, as long as they feature the mounting hole previosuly used to engage the latch.
Warning: the ring notch on the piece assumes you pushed the heat-set insert below the surface, as the manual says.
Instructions:
- Press the heat-set insert into the printed part;
- Cut the connector (if present) off the thermistor;
- Insert the bare wires throught the hole;
- Lightly pull it out;
- Insert the thermistor into the mount. Do not apply too much pressure, twist it in.
| Print Instructions |
| Material: Recommended ABS/ASA |
| Layer Height: 0.2 [mm] |