1 / 2
Thermistor Antenna
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- GNU General Public License v3.0
BOM:
- SHCM3x30mm [1x]
- M3 Voron heat-set insert [1x]
Compatibility:
- Voron ClockWork2 Extruder;
- CW2 style mounts for other extruders, as long as they feature the mounting hole previosuly used to engage the latch.
Warning: the ring notch on the piece assumes you pushed the heat-set insert below the surface, as the manual says.
Instructions:
- Press the heat-set insert into the printed part;
- Cut the connector (if present) off the thermistor;
- Insert the bare wires throught the hole;
- Lightly pull it out;
- Insert the thermistor into the mount. Do not apply too much pressure, twist it in.
| Print Instructions |
| Material: Recommended ABS/ASA |
| Layer Height: 0.2 [mm] |