1 / 3
Holder for Xiaomi Temperature and Humidity Monitor 2 remix — image 1
1 / 3

Holder for Xiaomi Temperature and Humidity Monitor 2 remix

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

The original design was built like a tank, so I needed a weakened version ;)

Rating
5 / 5
Likes
4
Downloads
31
Makes
1
Views
308
Reviews
1

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — Share Alike

I needed a pla friendly weakened version of the original design without any screws. 

 

This design is too close to the ender 3 v2's screen if you use it on the right side, but I have no problems since I use it towards the front of the printer as seen in the photos.

The slots between the leg and case part is tight and small, but it will work fine if you pay attention cleaning the tiny overhangs if there are any.

No supports needed and if you need support then its time to upgrade your printer.. :)

 

cheers!

 

Tags