Gaggiuino - Rancilio Silvia Touchscreen Housing (replaces water tank lid)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Modification of Loogle's Gaggia Classic housing to make it fit on an Rancilio Silvia
- Rating
- 0 / 5
- Likes
- 25
- Downloads
- 169
- Makes
- 2
- Views
- 2,546
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is a remix of Loogle's Gaggia Classic / Pro touchscreen enclosure. That model is a remix of a project from LikeableBump. Consider visiting these projects and liking them!
https://www.printables.com/model/280617-gaggiuino-gaggia-classic-pro-touchscreen-housing-a
https://www.thingiverse.com/thing:5236286
Updates
13/2/2023: Changed the model to fit the tank better. Had to remove the tamper holder.
Hardware
- 2 M4x10 button-head screws
- 2 M4 nuts
- Loctite 242/243 or equivalent
Attaching the lid:
- Cut a piece of 1.75 mm filament with 5-10 mm extra length and use a heat gun to straighten if necessary
- Thread filament through the plate and lid holes and check that the lid rotates freely
- Melt one end of the filament to the plate with a soldering iron
- Cut the other end of the filament so there's about 1 mm extra sticking out of the plate to melt
- Melt other end of the filament to the plate with a soldering iron.
- File melted areas flush if necessary.
Recommended Print Settings:
PETG (preferred) or PLA, 0.4 mm nozzle, 0.2 mm layers, 30% infill, supports may be needed
Print settings:
Bambu Lab P1P
123-3D Black PLA (prefer use PETG)
0.2mm layers
215C nozzle
65C bed
20% infill (grid)
Supports: yes
Skirts: 5mm
