Gravity Boots (for the Smooth Gravity Spoolholder - Rock On Edition)

This is my first planned add-on for the Smooth Gravity Spoolholder (which is a Remix of Michal Fanta's Gravity Spoolholder for MMU2s)

Gravity boots allow you to set the slope angle of your spoolholder on the fly!

• Got a new spool that is just dying to unspool itself? Dial this puppy up to lift the front end of your Smooth Gravity Spoolholder up to 32mm!

• Things are running nicely and you don't want to put too much strain on your extruder? No worries, just dial it back all the way to bring it back to level for minimal pulling force.

There are files here for everyone! If you haven't printed your Smooth Gravity Spoolholder yet, use this base instead, and have an all-in-one solution!

Already printed your own Smooth Gravity Spoolholder? No worries, just print the Slide-on add-on!

It works great for me for fighting the friction of my narrow ikea passthrough!

Print instructions

I'm not going to get as granular with the manual color changes with this one as I did with the Smooth Gravity Spoolholder Rock On Edition.
Get creative, play with the colors - do what looks cool to you!

What to print:

• Either the full base or the slip-on add-on
  (see Smooth Gravity Spoolholder - Rock On Edition for the other parts needed for the full system)
• (2) Copies of the Gravity Boot Cleats

You'll need 2 LEGO 87697 Tires - these are super common, and if you have any old LEGO City trucks, you probably already have them, if not they can be found on www.bricklink.com for about 2 cents apiece.

Have fun, and Rock On!

Here is a link to the actual listing for this tire on Brick Link:https://www.bricklink.com/v2/catalog/catalogitem.page?P=87697&name=Tire%2021mm%20D.%20x%2012mm%20-%20Offset%20Tread%20Small%20Wide,%20Band%20Around%20Center%20of%20Tread&category=%5BTire%20&%20Tread%5D#T=C