IEM Headphone Cable Clip Clamp Thingies - Cable Splitter Clamps for differnt IEM cables
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple cable clip things-UPDATE:Tripowin x2 +Moondrop Aria and Salnotes 7hz Zero -may work with others, check dimensions
- Rating
- 5 / 5
- Likes
- 50
- Downloads
- 247
- Makes
- 2
- Views
- 2,295
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial
I tried a cable clip (see remix linked) but that was too thin for my Moondrop Aria standard para-cord IEM headphone cable (8.4mm inside diameter, 6mm cable hole). I liked the original clip so decided I to quickly recreate my own variation of it - my version uses the barrel / round splitter part of headphone cable to secure in place - simple snug fit with minimal cable stress.
Also modded clip part to have a bit more surface area and bite.
UPDATE #1: added a second version for the standard Salnotes 7hz Zero cable which might work with other cables - 6.7mm inside diameter, 5.2mm cable hole
UPDATE#2 05/10/2023: new version added for Tripowin Zonie 16 Core Silver Plated Cable SPC (2 pin-0,78, 2,5 mm, Moss) - 9.2mm ID 4.4mm cable hole and 11mm deep.
Simple, quick print - slot into place, holds well enough for my needs, job done 👌
Aria and Salnotes pic show quick n dirty prints (sure you can do much better): 0.6mm nozzle, 0.3mm layer height, PETG
2nd pic of Tripowin cable at 0.2mm layer height and standard 0.4mm nozzle. 100% infill
PLA and other filaments should work fine.
Maybe wasted my time uploading this as its a very specific thing but if not - do like n all that “sharing is caring” goodness 😉