Terminal for SSD1106 1.3'' OLED and NodeMCU v3 ESP8266, without soldering
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Works for Ahoy! installations using only female/female Dupont cables.
- Rating
- 0 / 5
- Likes
- 47
- Downloads
- 483
- Makes
- 0
- Views
- 3,683
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
This is a remix of an original terminal for a Wemos D1 Mini. Since I am unfortunately a total novice with regard to soldering, I was looking for an equally nice looking terminal, without the need to solder.
I increased the depth of the terminal housing a bit and increased cutouts for the NodeMCU, to fit it snugly into it. The housing is intended for MCUs with a size of about 48x25mm (length/width). There are a lot of variations, so please check beforehand! I used this model from Amazon DE.
I managed to fit a RF24L01+ antenna and a few 10 cm female-female Dupont cables into the case. Some drops of hot glue might help to keep components in place, but aren't absolutely necessary.
