Plain Nozzle Box (print-in-place, MK8/V6/Volcano)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A taller version of the remixed nozzle box so it fits MK8 and Volcano nozzles. Prints in place
- Rating
- 4.909 / 5
- Likes
- 62
- Downloads
- 454
- Makes
- 15
- Views
- 1,579
- Reviews
- 11
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of the original nozzlebox with options that fit Volcano and MK8 nozzles. Like the original, it prints in place and is locked by a magnet (6x2mm!) and an M3x6 (or smaller) screw. It doesn't come with any markings so that one can just add a sheet of paper (of which I attached a paper with the exact dimensions for a print-out)
The contraption is printed at an angle so that even dirty nozzles should fit – the bottom of the contraption is ~7mm apart while the top is ~6mm.
Thank you very much @dodasch for the original. It's been a very interesting journey trying to recreate this neat design.
The Onshape Document contains both versions, the box parameters can be changed easily, the tolerances and angles will probably be a bit trickier.
Printing
- 0.2mm layer height
- Well tuned flow (maybe lessen the outer-wall flow) so the hinge and the ball print properly
Assembly
- Press the 6x2mm magnets into the holes on the bottom part
- Screw the M3x6mm countersunk screws into the base of the top part
Warning
- I didn't print the standard version, but reduced the height of the contraption and the box compared to the volcano box.
- I didn't have 5x2mm magnets, so this version uses 6x2mm magnets. I can provide a 5x2mm version if there's demand for that.