Magnetic Hanging Cat
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cat-shaped magnetic decoration for your fridge, desk, etc.
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 64
- Makes
- 2
- Views
- 282
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Wall-mounted
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I took my favourite of mishkin2's cat shapes, added two magnet holes on the back, and made a little cutout for the eyes so you can mix and match colours to your liking. Have fun!
Should be printed at 0.2mm layer height. The cutout for the eyes is a press-fit and shouldn't require glue; you can even pop it back out and swap eye colours. You will need to glue in two 10x1mm magnets (one is not strong enough to hold the weight).
Updated 2023-07-11
The small 10x1mm magnets used in this design are not very powerful, and the cats would sometimes slip down a bit; to improve this, I added a third magnet hole to the back. I also made the magnet holes a bit tighter, so the magnets will also be press-fit and won't need any glue. Finally I suggest the following print settings:
- Layer height 0.2mm
- Bottom layers: 5
- Top layers: 0
- Perimeters: 4
- Infill: 0%
Using these settings, the back of the print will be hollow, which shaves off about 20% of the weight and makes the cat even more stable.