LayersFactory
Report model
1 / 3
EZout v2 Ender 3 Pro Filament Runout Sensor Guide — image 1
1 / 3

EZout v2 Ender 3 Pro Filament Runout Sensor Guide

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

beerman

beerman

@beerman

A remix of a remix of a remix. I remixed the version for the Ender 3 to match the dimensions of the Ender 3 Pro.…

Rating
5 / 5
Likes
8
Downloads
52
Makes
0
Views
564
Reviews
1

Updated at source:

Model information

Source
Printables
Category
Other Ideas
License
Creative Commons — Attribution — Noncommercial
DetailsFiles (1)Makes & comments (Makes: 0) (Comments: 1)Remixes (0)Collections (7)Related

A remix of a remix of a remix.

I remixed the version for the Ender 3 to match the dimensions of the Ender 3 Pro. Ionize's version had the guide and sensor 4mm over to the left which didn't leave a straight path for the filament.

The sensor I used is a cheap one from aliexpress that I'm using with the Octoprint Filament Runout Sensor reloaded plugin.

https://www.aliexpress.com/item/33053134385.html?spm=a2g0o.productlist.main.1.281f20dcf4jkIA&algo_pvid=0ab658af-25e5-4bbd-95bd-e085c7ecac49&algo_exp_id=0ab658af-25e5-4bbd-95bd-e085c7ecac49-0&pdp_npi=3%40dis%21GBP%211.54%211.41%21%21%21%21%21%402145265416818387389417339d06e0%2112000028969959871%21sea%21UK%21174767213&curPageLogUid=kfyBrcMj3XpF

I removed the middle pin from the plastic connector and plugged this into ground on the pi (PIN 14). The plastic connector then plugs into pin 13 for the sensor wire and pin 17 for the 3.3v.

For the Octoprint plugin the options I used are:

PIN 27 (pin 13 is GPIO 27)

Switch Type: Normally Closed

Board Pin mode: BCM

Board Pin resistor mode: Pull up resistor

Category: 3D Printing

Tags

crealityenderoctoprintfilamentsensorthingiversecrealityender3ezoutfillamentrunoutrunoutsensorender3ezout