MMU Filament Spool Bushings - Snug Fit
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a more snugly-fitting version of @Dan_20570's idea to add washers/bushings to the MMU Lack spool holders
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 39
- Makes
- 1
- Views
- 352
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Public Domain
This is just a more “snug-fitting” version of @Dan_20570's idea to add washers/bushings to the v2 Lack Enclosure's MMU spool holders, to keep the spindle rods from falling out all the time. When I printed the original, it wasn't quite a tight-enough fit to keep the rod from falling out. It's possible my printer is just calibrated a little differently, or things shrunk a tiny bit, etc.
So I made this quick remix, just to tighten up the dimensions a little bit.
As with the original, I recommend printing this with a somewhat flexible filament.
I printed these with the following setup:
- Fillamentum Flexfill 98A TPU (in “Luminescent Green”)
- Prusa i3 MK3S+
- Textured Prusa PEI spring steel sheet (textured helps it not to stick too much)
- Loosened the idler spring screw (basically as loose as it will go without falling out)
- default 0.4mm nozzle
- PrusaSlicer's built-in profile for Fillamentum Flexfill 98A (nozzle: 240º, bed: 50º)
- 0.2mm layer heights (“0.2mm SPEED” preset)
The end result is that the spindle rods no longer fall out every time I change the filaments on these spools! With these installed, the metal rod does not spin freely relative to the plastic… but all together, the spools are still very much able to spin freely in their holders, with no meaningful friction.