1 / 4
Zen Kinetic Art Wind Spinner with magnetic bearing — image 1
1 / 4

Zen Kinetic Art Wind Spinner with magnetic bearing

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Zen Kinetic Art Wind Spinner, uses magnetic force to balance spinning parts on a small point.

Rating
5 / 5
Likes
120
Downloads
142
Makes
1
Views
2,496
Reviews
1

Updated at source:

Model information

Category
Sculptures
License
Creative Commons — Attribution — Noncommercial

The flowering plant-style design spins with a slight breeze.  The model has smooth movement with very little resistance to spin using magnetic bearing.

 

All parts were printed without support.

Non-printed parts:

    One copper penny for the bottom of the magnetic assembly

    One 3" Screw x 1/8" diameter 32 thread pitch

    One 17 x 1 ¼" stainless brad nail (Hillman 532672)

     3 - M3 4mm screws

     27 Neodymium Magnets 10mm x 2.5mm round with 3 mm hole (50pack $8 at amazon https://www.amazon.com/gp/product/B09ZLFNZ4S )

 

All magnets face the same direction both in the housing and the spinning section.  The ones I used are beveled for a screw on one side, so easy to tell the polarization.  The brad nail head is ground down and both sides are sharpened.  There are 3 rows of magnets in the magnet body housing.  Magnets on the spinning part are adjusted with the plastic nuts.  Each set of 3 should be just below the level of the matching magnet row in the main body.  The nut with the brad nail can also be turned to raise and lower the entire spinning assembly for desired clearance. 

 

 

 

Tags