Festool 449666 fence clamp component (discontinued, for MFT 1080 / 800)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a component (part 31 or 25 on the explosion chart) of the fence holder for the original MFT 800 /1080. All the…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 33
- Makes
- 0
- Views
- 509
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
This is a component (part 31 or 25 on the explosion chart) of the fence holder for the original MFT 800 /1080. All the other components are available to order as of 07/2021. You can gain a few centimetres of cross cut capacity by using two of the holders instead of the originally provided one plus angle adjuster as demonstrated by Peter Millard (https://www.youtube.com/watch?v=0V-p5F7SjO4). A very small part on the bottom part has not been modelled as it's not necessary and would have made supports necessary. Easy print.
Edit: because the opposite side of the fence was moving a few millimetres up with the original clamps I also redesigned the upper part to have a tighter fit in the fence groove. Depending on the hight of the mdf my 1mm high washers might make the clamps an even better fit. I'm finally happy with the solution.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
200
Infill:
38
Filament: PolyMaker PETG
Category: Tools