Yeti Lid Holder - 3 Sizes w/ Optional Magnet for Satisfying *Thunk*
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Yeti lid holders. One for each size small, medium and large. Has an opening for an magnet if desired!
- Rating
- 5 / 5
- Likes
- 39
- Downloads
- 380
- Makes
- 1
- Views
- 1,499
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
Yeti Lid Holder
https://i.giphy.com/media/zvpds7EGBb5rDojsNq/giphy.mp4
I created this model to hold Yeti lids. It has a 10mm square hole in the base that can hold a 10mm square magnet, if desired. For the yet lids that have the magnetic slider, this gives a nice hold and a satisfying thunk that seats and holds the bottom lid in place. Simply add a colour change or pause print right at the point before the top of the magnet hole is printed and insert the magnet. I have added a picture of how I accomplished it in PrusaSlicer. It should snap tight to the build plate underneath and won't be pulled up by the extruder. If you do not want the magnet, just print as is. The hole will be covered regardless and the structural integrity will be the same.
Sizing
There are three sizes:
- Small - Inner diameter of 72.5 mm
- Medium - Inner diameter of 89 mm
- Large - Inner diameter of 101.5 mm
Cut the top of the model off in your slicer and print a test fit for the lid. I designed the fit to be pretty snug with wiggle room on the order of mm. I have no idea if other printers/slicers will print correctly within these tight margins.
Supports
Add supports on the opening overhang above the base. I added an image of where the supports go in PrusaSlicer.
Printed
I printed on a Mk3s+ with PrusaSlicer using black PLA.