Keychron Q1 v2 low profile case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Keychron Q1 v2 bottom housing with a lower profile than the original one
- Rating
- 0 / 5
- Likes
- 17
- Downloads
- 55
- Makes
- 0
- Views
- 752
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
Since the Keychron Q1 was a bit too high for me, I rebuilt the bottom case with a lower profile.
To make it printable on a normal sized printer, I split the case in two parts. In the v1 I added dovetails and a slight clearance to the two parts so they can be easily plugged together. Unfortunately, this creates a gap between the parts.
When assembling, I noticed that the dovetails and clearance are not necessary at all, so I made a v2 without dovetails, where the gap should be much less visible. I will print these parts next, so they are not tested yet.
For large printers, I have included the complete case without the split.
I attached small rubber feet to the bottom.
-------
Print settings:
0.28mm
10 % rectilinear infill
standard supports for the screw holes
5mm brim to prevent lifting
-------
Next up I will rebuild the upper case, with rounder corners, as the sharp corner of the original case always bothers me on my left hand. :)
As I am a total newbie in rebuilding and constructing with Fusion, I am open for constructive criticism and ideas.