Keychron Q1 v2 low profile case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keychron Q1 v2 bottom housing with a lower profile than the original one
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 752
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Since the Keychron Q1 was a bit too high for me, I rebuilt the bottom case with a lower profile.
To make it printable on a normal sized printer, I split the case in two parts. In the v1 I added dovetails and a slight clearance to the two parts so they can be easily plugged together. Unfortunately, this creates a gap between the parts.
When assembling, I noticed that the dovetails and clearance are not necessary at all, so I made a v2 without dovetails, where the gap should be much less visible. I will print these parts next, so they are not tested yet.
For large printers, I have included the complete case without the split.
I attached small rubber feet to the bottom.
-------
Print settings:
0.28mm
10 % rectilinear infill
standard supports for the screw holes
5mm brim to prevent lifting
-------
Next up I will rebuild the upper case, with rounder corners, as the sharp corner of the original case always bothers me on my left hand. :)
As I am a total newbie in rebuilding and constructing with Fusion, I am open for constructive criticism and ideas.