Christmas light bow (Weihnachts Lichterbogen)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.27 – €0.33 net (excluding VAT)
For file: innenabdeckung_015mm_pla_mk3s_20m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.30 excluding VAT (range midpoint).
- Weight reported by the author
- 3 g
- Print time reported by the author
- 19.8 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A light bow with LEDs and space for a power supply and electronics in its sockets.
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 44
- Makes
- 1
- Views
- 839
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Winter & Christmas & New Year's
- License
- Creative Commons — Attribution — Noncommercial
A light bow with LEDs and space for a power supply and electronics in its sockets.
The flames are actually taken from https://www.thingiverse.com/thing:3120235
The candles are made with 5mm warm white leds.
I used a 5V power supply with a 180 Ohm resistor on each LED.
The bow, sockets and candles are glued together. The bow cover is just inserted under the bow but not glued. The socket covers are screwed using 3x20mm wood screws.
In the left there is a hole to mount a power cable and I placed a 5 volts power supply into the socket. In the right socket there is a esp8266 board with a esphome firmware.
This way the light bow can be directly integrated into the homeassistant network.
Print instructions
Printed in white PLA, transparent for the flames.
0.15mm layer height
The bow (bogen.stl) uses supports all over, the candles (kerze.stl) and the sockets (fuss1.stl, fuss2.stl) support on the build plate.
The candles should also be printed using a brim.