Rook E3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is my mod for the Rook 2020 to make it use all the parts from an Ender 3 V2.
- Rating
- 5 / 5
- Likes
- 77
- Downloads
- 258
- Makes
- 2
- Views
- 3,802
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This will not me updated. The Rook 2020 Scalable and the Ender NG project has made this obsolete.
This is my mod for the Rook 2020 to make it use all the parts from an Ender 3 V2.
This needs an aditional z-motor and leadscrew
Uses most of the hardware from the Rook 2020 BOM with different extrusion-lengths.
Wiring and electronics from the Ender 3 V2.
(Full BOM will be made when it is built and tested)
Extrusion lengths are:
- 8x350mm for top and bottom frame
- 2x350 for the bed
- 4x400mm for the Z-axis.
- The bed needs a 250 extrusion, there is a 4040 on the ender you can use. if not, I recommend using 2x250mm 2020 extrusions.
This gives you a build-volume of 230x230x300
You can scale this in Z, just remember that you need to scale the threaded rods aswell
- Uses 2x 350mm MGN9C rails on Y, and one 300mm MGN9C on X
- 4x 8x400mm Rods for the Z axis
Supports the stock Ender 3 electronics and can use Marlin with a custom firmware. (I will not use that, and will not make one)
I recommend klipper to maximize the potential of the motion system.
This is set up to use the Rookery Toolhead. (Want bigger fans? I got you)
STL's will be postet when it is fully built and tested.
Want to build this in a different size? Check out THIS
Want to help me beta-test this? let me know!
Please note that this has not been built yet, let me know if you want to build it!
