VzBoT Y Gantry for 1515 size X gantry
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is Y gantry bottom parts for the VzBoT Vz330 to replace X gantry to lighter weight 1515 size instead of 2020.
- Rating
- 0 / 5
- Likes
- 40
- Downloads
- 131
- Makes
- 0
- Views
- 2,033
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This is the Y gantry bottom parts for the VzBoT Vz330 used to replace X gantry to lower cost, lighter weight 1515 size instead of 2020 size.
The geometry and shape is based on the Vz330 V1.2's Y gantry except for minor differences and is fully compatible.
note: After the Vz330 V1.2 is released, the left and the right of the Y gantry are not common parts. If you are using less than V1.2, please re-printing and combining Y-gantry-top-left and Y-gantry-top-right released by official VzBoT.
BOM
| Part | STL | PCs |
| Left Bottom | This Y_gantry_1515_bottom_left-15.2.stl | 1 |
| Right Bottom | This Y_gantry_1515_bottom_right-15.2.stl | 1 |
| Left Top | The official Vz330 V1.2's Y_gantry_top_left.stl | 1 |
| Right Top | The official Vz330 V1.2's Y_gantry_top_right.stl | 1 |
| X end stop | The official Vz330 V1.2's XendStop.stl | 1 |
note: The standard inner width is 15.2 however please try to use 15.1 or 15.0 instead of 15.2 if your fitting is too loose. For my VzBoT I used 15.2 but use 15.0 now to use CF-ABS that is low shrinkage instead of standard ABS.
Examples of 1515 size rods
| Type | Weight(440mm) | Moment of inertia of area |
| A6063S−T5 square tube 15x15xt1.5 | 97g | 0.249×10^4 mm^4 |
| Misumi HFS3-1515 | 150g | 0.280×10^4 mm^4 |
| MakerBeamXL | 147g |
Note
Side dimple marks show the direction of the part. Illustrated below are the left part, the tooth side is the front and the smooth side is the back.