1 / 2
Kusba mount for Creality Ender 5 S1
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Solid permanent mount for a KUSBA that fits the default extruder of the Ender5 S1
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 63
- Makes
- 0
- Views
- 972
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Print in ABS, ASA or PETG if you are enclosing the printer to avoid the plastic deforming. Easy to print with no need for supports or heat-set inserts. The lid will keep dust away and it also has standoffs that will press the circuit-board firmly against the mount to eliminate any slop or play. Design also leaves a small air-gap to the extruder stepper as to not risk overheating the motor
BOM:
- 6x M3x10mm screws
- KUSBA ADXL sensor
- Printed parts
Mounting instructions:
- Attach the KUSBA with the flat side down
- Tighten down the lid firmly but no too hard as that could cause damage or strip the treads
- Screw into the exposed threads on the extruder with the USB-port towards the spool-holder