Bottom Cover for Seeed Studio ATX PSU Breakout
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple bottom cover for the Seeed Studio ATX PSU breakout board to reduce short circuit potential for messy makers.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 17
- Makes
- 0
- Views
- 222
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Public Domain
I've been using the Seeed Studio ATX PSU breakout board for a while now and nearly had an incident by leaving the board floating around the desk with lots of metal bits around. I decided to make a simple cover for the bottom to prevent short circuits on the bottom posts for the power lugs.
Both 0.4mm and 0.6mm nozzle g-codes are provided, make sure you select the right one for your machine.
The mounting holes are threaded for 3mm machine screws, but they also seem to work fine with 2.5mm screws commonly found in hard disk drive cases. I have included the Fusion 360 file, so feel free to modify them to your heart's content.
The 3mm wall and base thickness might be a bit excessive, 2mm should also work fine and print faster. The model is fully parametric, so use the Change Parameters command under the Modify tab to quickly change settings, and please let me know if something does not work as expected.