French Cleat Organizer for 3D Print Cleanup Tools
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This tool organizer for 3/4" French Cleat walls holds 5 flush cutters, 3 deburring tools, and 9 extra blades.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 72
- Makes
- 0
- Views
- 1,328
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
This organizer holds some of the most commonly used cleanup tools for finishing 3D prints. It has slots for 5 pairs of flush cutters, 3 deburring tools, and 9 spare blades. It can be used with a French cleat system and will stand on its own when removed from the wall and brought to the bench. It was designed with these specific tools in mind, but other brands may also fit.
As an Amazon Associate I earn from qualifying purchases. I get commissions for purchases made through links in this post. Purchasing using this link helps support my business and create more free digital resources.
I printed these in some no-name PLA on the Bambu P1P. It was approximately 250g of filament and 6.5 hours to print. The model will print without supports if oriented on its side.
Shells: 3
Supports: No
Infill: 20% (I used Gyroid)
Layer Height: 0.3mm
Brim: Yes
Keeping a clean and organized workshop with hundreds of kids working on different projects can be an organizational nightmare for STEM or engineering teachers. I'm hoping to make it a little easier for them by sharing some easy-to-use organizers like this one. Labels are integrated on each tool organizer to make it easy for students to match up tools to directions given by their teacher.
This tool holder is compatible with French cleats made from 23/32 (3/4" nominal) or 18 mm plywood but should work with any cleat at least 16mm or 0.625" thick. I use 3" strips of plywood for my cleats, then remove a small amount on the 45 degree cut side to remove the sharp corner.
There are two optional retaining clips that can be added on the side to ensure the tool holder stays on the cleat when removing individual tools. These are attached with an M3x15 Countersunk screw, which self-taps into the main part. This needs to match your cleat size, so I recommend a test print and adjusting the length to meet your needs and get a snug fit. They are also intended to be just a bit oversized, allowing you to file or sand down the bump that locks against the bottom of the cleat to get the perfect fit.