Neptune 3 Max CHEP E-Leveler2 G-Code File

I use the CHEP E-Leveler, and now the new E-Leveler2 device to level my Creality machines and recently added the Neptune 3 Max machine to my arsenal.  Using the original G-Code files provided by CHEP, I modified the code to add all 6 locations of the leveling knobs on the Neptune 3 Max.  

How to use this file:

1. Do not heat up your bed or nozzle prior to running this file.  
2. Run the file from the SD Card and the head will move to location 1 (front left) at 5.7 mm in height.
3. Slide the leveler under the nozzle positioning the nozzle above the target, and adjust the wheel until the light just turns on.  
4. After 30 seconds, it will move to position 2.  
5. Repeat this process for all 6 locations.  
6. You may then want to run the file one more time to make sure that all adjustments are still correct.
7. After all knobs are leveled, using the printer screen, run through the Auto bed leveling process and your bed should nearly perfectly leveled.  ** Do not run the manual level process from the screen **
8. Adjust the Z Offset until a sheet of paper has a slight amount of friction when wiggled, and then back out of the leveling screen to save your mesh.
9. Run a first layer test print to confirm that all points are level.  I suggest the Neptune 3 Max First Layer Calibration Test by Nils Kal - https://www.printables.com/model/476143-elegoo-neptune-3-max-first-layer-calibration-test/files
10. During the print, monitor to ensure you are getting a good first layer and if necessary, raise or lower the nozzle by 0.01 mm to dial it in as close as possible.