1 / 7
DigiSpark Attiny85 Enclosure | Bad USB Stick | Fake memory case | Rubber Ducky — image 1
1 / 7

DigiSpark Attiny85 Enclosure | Bad USB Stick | Fake memory case | Rubber Ducky

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A case that turns a Digispark Attiny85 into a (fake) USB stick. Feat. attachment hole, LED cutouts, optional pin access

Rating
4.8 / 5
Likes
54
Downloads
692
Makes
4
Views
4,108
Reviews
5

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

Another case to turn a DigiSpark Attiny85 into a (fake) USB stick (or just a nice enclosure, that's up to you ;-) ). This one features a consistent hole, which allows attaching it to a key ring or some kind of tie. There are also two 2 mm holes aligned with the LED indicators. You can easily insert a small piece of clear 1.75 mm filament there, cut it with a wire cutter and finally clean the remains using a scalpel.

For assembly, put the PCB under the first clip (start with the side without lateral headers) and lift the second one slightly with tweezers. The same goes for the lid. You're also going to need a M3 countersink screw and M3 nut. 

If you require pin access, there is also a different version with cutouts available.

Print in PETG. Don't use any other type of filament. Otherwise, the clips might break during assembly. Supports are not required. A resolution of 0.20 mm gave a decent result.

Tags