Compact Inline Belt Tensioner - GT2 6mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Compact Inline Belt Tensioner for 6mm GT2 belts.
- Rating
- 0 / 5
- Likes
- 45
- Downloads
- 217
- Makes
- 0
- Views
- 1,473
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Compact Inline Belt Tensioner
Created for 6mm GT2 belts. Tested at 35kgf.
Good for integration into Z belted mounts or X carriage mounts. (see CAD files)
Print
-0.14mm layer height or lower, 100% infill
-Arachne perimeters
-Well tuned filament extrusion/flow multiplier. Decrease flow if fitting is too tight
Hardware
-M3 Hex Nut x2
-M3 10mm Screw
-M3 20mm Screw
-Pin 2mm x 9mm (cut a custom pin from a metal nail, or use a piece of filament for testing)
Assembly
-Loop the belts and insert them into the channels. Wet them if hard to slip in.
-Insert pins/screws
-Insert hex nuts.
For the Knob, attach then nut onto the screw and push it hard in until it clicks.
-Attach pieces together and tighten the knob screw into the inner part.
-Adjust the tension by turning the knob
Enjoy!