99 cent ABL
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
99cent ABL Wire the switch in series with the Z end stop switch. Be sure to use the N.C. contacts in your switch. Add…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 8
- Makes
- 0
- Views
- 165
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
99cent ABL
Wire the switch in series with the Z end stop switch. Be sure to use the N.C. contacts in your switch.
Add some g-code to your startup code in cura or octoprint.
This worked for me in octoprint when using the Marlin 2.0 settings below.
G90
G28
G29
M500
M420 S1
G0 Z40 F1500
Here are the lines I've used In Marlin 2.
Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN //No need for a pin27 breakout board
FIX_MOUNTED_PROBE //probe doesn't move // usually for a capacitive or inductive probe
NOZZLE_TO_PROBE_OFFSET { -36, 0, -8.75 } //set this to actual measurements on your unit
AUTO_BED_LEVELING_BILINEAR //Ender 3 doesn't have the memory to use UBL
RESTORE_LEVELING_AFTER_G28 //With this M420 S1 shouldn't be needed, but suspenders and belt...
ENABLE_LEVELING_FADE_HEIGHT
PAUSE_BEFORE_DEPLOY_STOW //waits for you to deploy or stow z probe when homing or leveling // This makes using the manual probe simple
I have not tried it in Marlin 1.x.x
I am not responsible for any damage if you forget to deploy or stow the probe or if the settings and instructions provided were not correct or complete.
Print Settings
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
No
Category: 3D Printer Accessories