6-Slot AR10 Vertical Mag Holder (Magnet or Screw Mount)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lancer and PMAG AR-10 Compatible Vertical Magazine Holder
- Rating
- 1 / 5
- Likes
- 60
- Downloads
- 676
- Makes
- 0
- Views
- 2,045
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This six slot, vertical, AR-10/LR308 magazine holder can be mounted with either female threaded magnets, or screwed to the wall (pre-centered holes provided). If using magnets, I would recommend a minimum of two 35lb+ Neodymium magnets. I usually use two 50lb+ rubber coated Neodymium magnets with M6 screws because the larger bases are more stable.
They are compatible with most AR-10/.308 WIN/7.62x51 NATO magazines, including Lancer and PMags.
While I built these models in Solidworks from scratch, I did base them off the model listed so a shoutout to those who came before me.
Recommended Printer Settings:
50%+ Infill (I usually do 80% to help combat flex, but 50% seems fine)
I recommend Supports - If you can do trees or organic from the heatbed to support the lip overhangs, that is best. Otherwise, I would recommend supporting the lip overhangs off of the print itself and I usually don't worry about the fillets.
**Requires Minimum 9.8 × 8.2 inches / 250 × 210 mm Print Area