1 / 2
6-Slot AR10 Vertical Mag Holder (Magnet or Screw Mount) — zdjęcie 1
1 / 2

6-Slot AR10 Vertical Mag Holder (Magnet or Screw Mount)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Lancer and PMAG AR-10 Compatible Vertical Magazine Holder

Ocena
1 / 5
Polubienia
60
Pobrania
674
Wydruki
0
Wyświetlenia
2036
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This six slot, vertical, AR-10/LR308 magazine holder can be mounted with either female threaded magnets, or screwed to the wall (pre-centered holes provided). If using magnets, I would recommend a minimum of two 35lb+ Neodymium magnets. I usually use two 50lb+ rubber coated Neodymium magnets with M6 screws because the larger bases are more stable.

They are compatible with most AR-10/.308 WIN/7.62x51 NATO magazines, including Lancer and PMags. 

While I built these models in Solidworks from scratch, I did base them off the model listed so a shoutout to those who came before me.

Recommended Printer Settings:
50%+ Infill (I usually do 80% to help combat flex, but 50% seems fine)
I recommend Supports - If you can do trees or organic from the heatbed to support the lip overhangs, that is best. Otherwise, I would recommend supporting the lip overhangs off of the print itself and I usually don't worry about the fillets.

**Requires Minimum 9.8 × 8.2 inches / 250 × 210 mm Print Area 

Tagi