1 / 2
Ssupd Meshroom IcemanCooler reservoir mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a mount for the Ssupd Meshroom pc case to mount an IcemanCooler pump/reservoir combo
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 60
- Makes
- 0
- Views
- 1,192
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- GNU General Public License v2.0
This model allows mounting of the Iceman Cooler pump/reservoir combo onto the backside of the Ssupd Meshroom case.
Unlike the ssupd marketing material, I chose to mount this onto the Horizontal PCI card slot by removing the existing plates and made this design.
(The image features an older revision of the model where I realised I had space to make a cable management channel, the model has been updated to have this channel modeled and some structure added for rigidity.)
Printing:
- No real challenge in printing, I used 0.2mm.
- Brim should not be necessary as it is a large flat object.
- recommend material that is unlikely to warp from exposure to heat. I used prusament ASA.
Mounting:
- The three screws from the PCI card cover can be re-used.
- The mount is screwed in from the inside of the case.
- Screw the reservoid using the two lower screw holes, refer to image, top screw holes are not used.
- Route the pump molex and pwm cable through the very bottom channel
- Make sure your angled fittings can clear the mount as the mount should be +/-2.2mm wide with a small gap for the case metal width