1 / 3
Improved stock part cooling duct for Ender 5 S1 — image 1
1 / 3

Improved stock part cooling duct for Ender 5 S1

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Optimized part cooling duct for the Ender 5 S1. Better aesthetic, wider ducts and slimmer sides which increase clearance

Rating
5 / 5
Likes
70
Downloads
544
Makes
5
Views
2,477
Reviews
5

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

New Revision is out!
Re-routed the ducting so it no longer rubs/collides with the mount for the end-stop on the X-axis. Since there could be negative effects by using the older version I have removed it and I strongly suggest that you print out the new one if you previously printed this out

Introduction
This is a remix of the Ender 5 S1 duct made by Kevin Cooper. Most of the mount is unchanged but the ducts are all re-made from the ground up to improve on the aesthetics and performance of the fan duct.
 

Why should you print it?
The inside width of the ducting is more consistent and has no restrictions midway which should improve the overall flow. The outlets are also moved forward a slight bit as to be more centered around the nozzle. The overall width is also thinner which allows for enough clearance to use a zero Y-offset mount for your CR-touch, it is verified to work with my previously remixed mount that can be found here but may work well with others too.

It could also be a good idea to print one out as a backup in case you original duct is damaged
 

Printing instructions
This should be printed in ABS or ASA, especially if you intend on printing high temp materials enclosed. PETG was tested and works fine for PLA/PETG in open air, however the tips of the duct did deform slightly over time when printing ABS in an enclosure.

Supports are required but only from the build-plate, if you allow supports on the part it will generate supports inside of your duct which will be hard or impossible to remove.

It may also be good to make sure that your printer is able to bridge the ~15mm gap inside of the base of the duct. Failed bridges inside the duct are possible to remove with tweezers but it may leave a rough surface.
 

Example settings
The duct featured on the photos was printed in an enclosure using black PrimaVALUE ABS and the following settings: 

  • Infill: Cubic @ 15%
  • Walls: 3 @ 0.4mm line width
  • Bottom/Top layers: 4 @ 0.2mm layer height
  • Supports: Yes, normal on build-plate only
  • Temperature: Nozzle@260c & Bed@110c

Tags