MH-ET Live D1 mini ESP32 Case
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.67 – €0.82 net (excluding VAT)
For file: case_02mm_pla_mini_46m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.74 excluding VAT (range midpoint).
- Weight reported by the author
- 9 g
- Print time reported by the author
- 45.6 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
For a small project I needed a narrow case for my ESP32.
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 278
- Makes
- 4
- Views
- 4,000
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
For a small project I needed a narrow case for my ESP32. Of course I found appropriate templates - only I was not satisfied with them. Especially the fact that the lid had too much play and then you would have had to glue this.
Therefore, I have unceremoniously constructed a new housing and made the lid dimensionally accurate, so that it clamps and you can do without glue.
Other highlights:
- A hole in the bottom to be able to push the board out from behind e.g. with a toothpick
- lugs on the lid to fix the board nicely
- symbol in the lid to ensure good ventilation of the board
- a hole for the visibility of the two status LEDs
- and so that the lid can be removed again, there is a recess for a screwdriver.
My goal is always to include original 3D file so you are able to change designs according your needs.