Battery Door for Yongnuo YN465 SpeedLite
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My YN465 flash took a dive off a lightstand a few years ago and the battery door broke, I kind-of got it to stay in…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 14
- Makes
- 0
- Views
- 189
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial
My YN465 flash took a dive off a lightstand a few years ago and the battery door broke, I kind-of got it to stay in place and it worked until last week when it finally failed.
So I designed this replacement door, this is a new design and not a model of the original door - I made it easier to 3D print than the original design.
I only tested it on the YN465 but it will probably fit all the YN4xx models with the annoying sliding door.
The door has electrical contacts, I used a conductive band (probably copper) from an old broken power strip, there are slots in the model to hold them in place.
Print in 100% infill and support touching buildplate (the small "tooth" at the far side requires support but if you add support everywhere it will fill the little slots for the conductive bands).
I printed in PLA (because I had black PLA available), sliced with Cura and printed on my Robo3D R1+
Update
Cura decided this model does not need auto-generated support, Cura was very wrong and my batteries were very on the floor.
I've added a version with supports, the support doesn't touch the side of the door so it doesn't leave a mark when removed, use a sharp knife of a small wire cutter to remove the support from the tooth
Update 2
I wrote a long explenation but thingiverse logged me out and deleted it, so here's the really short version
- PLA not durable enogth, I switched to nylon, other materials (like ABS) would probably be ok
- I made a 2nd version, it connects better
Category: Camera