1 / 4
FLSun Super Racer Hotend - 5015 - Sherpa/Orbiter v2 - Direct Drive or Bowden — image 1
1 / 4

FLSun Super Racer Hotend - 5015 - Sherpa/Orbiter v2 - Direct Drive or Bowden

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A new hotend design for the FLSun Super Racer to work with original Hardware + an Sherpa/Orbiter v2 and 5015 fans.

Rating
3.5 / 5
Likes
29
Downloads
171
Makes
1
Views
1,776
Reviews
2

Updated at source:

Model information

License
Creative Commons — Attribution

The model works with a bowden setup as well as an Orbiter v2.

Sherpa design is untested, but should work. Will update when confirmation of it working. 

Additional hardware (screws and such):

  • 8 - M3 heat set inserts
  • 2 - M4 heat set inserts
  • 2 - 20mm M4 screws
  • 2 - 25mm M4 screws (Instead of the 25mm M4's, you can also use 2 additional M4 heat set inserts and 2 additional 20mm M4 screws)
  • A few additional M3 screws… I think I only needed 2 additional 10mm M3s
  • You need around ~34mm of bowden tubing between the output of the orbiter v2 and the stock heatbreak

 

 

Please note: the screw for the fan ducts should be screwed in from the TOP of the effector plate. This is opposite how it is installed by default (see image). 

My Klipper config for the extruder:

##############################################################
# Extruder - Orbiter V2
##############################################################

[extruder]
step_pin: PD6
dir_pin: PD3
enable_pin: !PB3
microsteps: 16
full_steps_per_rotation: 200
rotation_distance: 4.656
nozzle_diameter: 0.400
filament_diameter: 1.750
max_extrude_only_distance: 500
max_extrude_only_velocity: 120
pressure_advance: 0.025                   
pressure_advance_smooth_time: 0.03    
heater_pin: PE5
sensor_type: EPCOS 100K B57560G104F
sensor_pin: PC1
#control: pid
#pid_Kp: 18.372
#pid_Ki: 0.603
#pid_Kd: 139.853
min_temp: 0
max_temp: 245
max_extrude_only_distance: 600.0

[tmc2208 extruder]
uart_pin: PD9
interpolate: true
run_current: 0.85 #**
hold_current: 0.100
sense_resistor: 0.150
stealthchop_threshold: 0
driver_TBL: 0
driver_HEND: 6
driver_HSTRT: 7
driver_TOFF: 4

If you want to move to a reverse bowden tube with this setup, not you'll want to reverse the bowden coupler in the top of the machine (see images below).

From here

To here

Tags