FLSun Super Racer Hotend - 5015 - Sherpa/Orbiter v2 - Direct Drive or Bowden
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A new hotend design for the FLSun Super Racer to work with original Hardware + an Sherpa/Orbiter v2 and 5015 fans.
- Ocena
- 3,5 / 5
- Polubienia
- 29
- Pobrania
- 171
- Wydruki
- 1
- Wyświetlenia
- 1769
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
The model works with a bowden setup as well as an Orbiter v2.
Sherpa design is untested, but should work. Will update when confirmation of it working.
Additional hardware (screws and such):
- 8 - M3 heat set inserts
- 2 - M4 heat set inserts
- 2 - 20mm M4 screws
- 2 - 25mm M4 screws (Instead of the 25mm M4's, you can also use 2 additional M4 heat set inserts and 2 additional 20mm M4 screws)
- A few additional M3 screws… I think I only needed 2 additional 10mm M3s
- You need around ~34mm of bowden tubing between the output of the orbiter v2 and the stock heatbreak

Please note: the screw for the fan ducts should be screwed in from the TOP of the effector plate. This is opposite how it is installed by default (see image).
My Klipper config for the extruder:
############################################################## [extruder] [tmc2208 extruder] |
If you want to move to a reverse bowden tube with this setup, not you'll want to reverse the bowden coupler in the top of the machine (see images below).
From here

To here
