GoPro Compatible Mount for Original Prusa Enclosure OPE
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A GoPro compatible mount for the front right corner of the Original Prusa Enclosure
- Rating
- 4 / 5
- Likes
- 22
- Downloads
- 92
- Makes
- 1
- Views
- 466
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution
This is a GoPro-compatible mount that can be installed in the center of the front right corner of the Original Prusa Enclosure. It's an optimal position for a webcam that faces the build plate.
The mount is moved slightly forward to allow access to the knob. I'd recommend using a short or medium length knob. The ultra long original GoPro knobs might interfere with the door.
For compatible thumb screws and arms check out the Modular Mounting System Arms. Any GoPro-compatible knob will work though.
| Note: I don't own a Prusa Enclosure and haven't been able to test a real-world installation. However, I've tested the part for printability and fit of the hex nuts. This model is based entirely on measurements taken from the CAD file of the enclosure. Please provide feedback about the fit if you try it. |
 |  |
Required Hardware
| Qty | Part | Sourcing |
|---|---|---|
| 2 | M3x6mm Socket Head or Button Head Cap Screw | Aliexpress |
| 2 | M3 DIN934 Hex Nut | Aliexpress |
| 1 | M5 DIN934 Hex Nut ** | Aliexpress |
** Don't use Nyloc nuts. Shear forces induced during unscrewing when using Nyloc nuts can lead to layer delamination.
Printing
Print the part in the original orientation. The STL file is pre-rotated for printing.
- Material: ASA, ABS, PETG, etc. (material must withstand temps inside enclosure)
- Extrusion width: 0.45mm
- Layer height: 0.2mm
- Perimeters: 4
- Infill: 15%
- Supports: No
Installation
- Insert the hex nuts into the printed part.
- Place the part over the center holes of the front right frame corner on the inside the enclosure.
- Fasten the part with the M3x6mm screws.
Additional Credits
- The enclosure shown in the illustrations is the Original Prusa Enclosure by Prusa Research.