Serious Spring Clamp
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The only durable part in spring clamps is the spring. Even my trusty (pricey?) Wolfcraft clamps finally fail after…
- Rating
- 5 / 5
- Likes
- 62
- Downloads
- 179
- Makes
- 1
- Views
- 1,837
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The only durable part in spring clamps is the spring. Even my trusty (pricey?) Wolfcraft clamps finally fail after several years of service. Planned obsolescence ? Maybe. What if we can make stronger parts with long lasting as goal ?
Jaws opening <60mm (2"3/8).
BOM :
2x handles (3d printed)
2x pivot jaws (3d printed)
1x Reclaim spring from broken spring clamp2x M330mm screw (ideally set screw type)
1x M4*30mm screw (ideally set screw type)
*Spring max size:
- Wire 2.5mm max diameter.
- Coil: 10mm height x 15mm diameter.
- Legs: from center max 50mm long.
/!\ Assembly can be tricky or dangerous for unskilled people. Please wear safety protection, especially safety glasses. See in Post-printing section for the safest assembly procedure I found out.
Print Settings
Printer Brand:
TEVO
Printer:
Tarantula
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
16% 4xPerimeters
Filament: PM PLA Khaki + Orange
Notes:
Support from bed and part.
Please reorient the jaws to print them flat.
The handles can be printed in place.
Post-Printing
The safest and easiest way I found is:
1. Screw the pivot jaws in place with M3 screws 2. Secure each spring leg into each handle with a pair of locking pliers* 3. Insert the two handles in place into a vice 4. Slowly tight the vice and align the two handles in place 5. Insert the M4 screw (the M4 screw should be inserted easily) 6. Release the vice 7. Remove the locking pliers 8. Enjoy * Some thermoplastic can be brittle, please don't clamp too tight the locking pliers.Category: Tools