1 / 5
Rod seal longshot breech — image 1
1 / 5

Rod seal longshot breech

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Experimental longshot breech using rod seal instead of conventional piston seal - abandoned

Rating
0 / 5
Likes
0
Downloads
18
Makes
0
Views
213
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

https://www.reddit.com/r/Nerf/comments/q412iw/rod_seal_longshot_experimentation_details_in/

Longshot rod seal (instead of pusher piston seal) breech experiment

pusher_01 was the one I used, that eventually snapped.

pusher_02 and pusherreinforce should hopefully hold together a little better (oring seat a little more narrow also).

Uses 3.5mm (28mm ID) o rings for lipless base, and 2.5mm (14mm ID) o ring for the rod seal at the breech

I eventually abandoned the notion of 3D printed breeches due to struggles with reliability, but for the record, it worked OK, I found it only slightly less efficient than conventional brass/pusher breeches (I suspect that the improved airflow mitigated leakage and dead space losses), and reliability didn't seem too bad.

Category: Mechanical Toys

Tags