Elfa Utility Board Wera Micro Drivers Hanger
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Do you have a set of Wera Micro Drivers, an Elfa Utility Board, and the need to hang the drivers somewhere?
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 59
- Makes
- 0
- Views
- 724
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Do you have a set of Wera Micro Drivers, an Elfa Utility Board, and the need to hang the drivers somewhere? Then this is probably something you might find useful.
I decided that some of my previous designs for holding tools on the board were taking up too much of the valuable real estate so I decided the only direction was to project out from the board. So that's what this does and it works well.
The openings in the side are big enough for the narrow portion of the driver to slip through and then when seated, they're unlikely to accidentally fall out, all the while being close at hand.
I would imagine this would fit other drivers of a similar design and from what I've seen, there are a lot that share this same form factor.
Print instructions
Prints with the flat side down, supports are recommended on the build plate.
Print file sliced for PETG.