RJ45 flexible strain relief
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Strain relief for RJ45 connector
- Rating
- 0 / 5
- Likes
- 56
- Downloads
- 215
- Makes
- 0
- Views
- 967
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
I needed some strain relief, but all I could find was not optimal for 3d printing. I modified
Eiki Martinson's design a bit ( cable hole was too small, the ribs needed some fillets to be able to print properly and had to make the lever cover a lot larger cause it was preventing the locking mechanism from working).
I tested it with cat5e and cat6 cables ( both of them around 5,5-6mm in diameter), both the cable and the connectors fits tightly, it wont come off on its own.
Needs to be printed in flexible material. I printed in 95A TPU, probably a bit softer material would be better, but it work perfectly with this aswell.