1 / 4
120mm Fan Adapter for Levoit 200s Air Filter with ESPHome — image 1
1 / 4

120mm Fan Adapter for Levoit 200s Air Filter with ESPHome

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Simple air filter kit with common media and a dead easy Home Assistant setup.

Rating
0 / 5
Likes
29
Downloads
84
Makes
0
Views
1,582
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

I needed an air filter for the bus I live in and it needed to be able to mount to the wall out of the way. The clips on this design make it robust when assembled but easily disassembled when its time to replace the filter. 

 

Electronics

I used my FLIP_C3 board which allowed me to use minimal parts. Since this is for my bus that runs a 24v off-grid system I chose a 24v fan from noctua with a 4-pin connector allowing for PWM control. You can so the same thing with a 12v fan, but you'll just have to match the input voltage either directly from a battery or from a wall transformer. You could definitely use the on-board buck converter to power a 5v fan, but I'm not sure how well that would work. I will test and see since that would allow you to use the full 60v tolerance of the FLIP_C3 and alternately use the USB-C port.

You can obviously use whatever electronics you want, but I found that my FLIP_C3 is a great fit for this project.

I personally use ESPHome and once you get yours set up and adopted, you can add the following config tailored for the FLIP_C3:

 

sensor:
  - platform: pulse_counter
    pin: 
      number: 6
      mode:
        input: true
        pullup: true
    name: PWM Fan RPM
    id: fan_pulse
    unit_of_measurement: 'RPM'
    filters:
      - multiply: 0.5
    update_interval: 3s

output:

  • platform: ledc pin: 7 frequency: 10000 Hz id: fanhub_pwm

fan:

  • platform: speed id: thefan output: fanhub_pwm name: "PWM Fan" restore_mode: RESTORE_DEFAULT_OFF

binary_sensor:

  • platform: gpio pin: number: 9 mode: input: true pullup: true inverted: True name: Boot Button on_press: then: - fan.toggle: thefan

Tags