Cap for HobbyPark Driver / Screwdriver
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple end cap for hollow aluminum handle drivers/screwdrivers. Also useful to color code drivers.
- Rating
- 5 / 5
- Likes
- 11
- Downloads
- 44
- Makes
- 1
- Views
- 237
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
I purchased a set of the very common allen wrench/hex key drivers on Amazon and was shocked they didn't come with caps on the ends. Leaving them hollow was driving me crazy. This is just a simple cap to help keep me sane. It is also useful to color code the drivers.
I used rubber O-rings that I had on hand to secure the cap in a non-permanent manner. O-ring dimensions are 3/32" wide, 3/8" ID. Depending on which of the drivers you have, OD is 9/16" or slightly smaller.
Print top of cap down. No need for supports.
I've used these on three different sets of drivers with success. The HobbyPark drivers that I originally purchased are linked below.