Quadmula Siren SF3 Armguard 9x9mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Armguards that fit 9x9mm motor mounts of the P1604 Pacer on a quadmula siren sf3 arm tip.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 61
- Makes
- 0
- Views
- 517
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
While building my o3 siren sf3 with those P1604, I realized, there are no fitting arm guards. Since I did not rush my build and wanted to craft a quad, that pleases my aesthetics in every aspect it was no question to design my “own” arm guards.
I am by no means a good pilot so they had to serve the purpose of fitting, obviously. Carry a fresh, colorful look and also absorb my weakest moments behind the sticks.
Like every part, I do usually start from a reference picture and build parts from scratch. So I did here. It was a pretty straight forward job and it took my only a couple of iterations and smaller refinements to get to a result I was satisfied by.
I did print it with TPU 95A from Saintsmart. As you can witness from the pictures, they did hold up and still run strong. (You also might have felt the urge to tell my to clean my drone. This. Is. FPV! ;-) )