6 models
I made these for my 1995 4Runner for the front bumper license plate. They fit a 9mm x 9mm square hole and use a #10 screw. Tested fit - perfect. These are best printed in nylon. Try them and post your results in the comments. Print…
The center hole is 3.5mm to allow for it for M4 hardware, but the f3d file (and step file) is available for you to customize to your needs. Would definatily recommend PETG for this, as it need to be a little flexible to not crack when…
While building my o3 siren sf3 with those P1604, I realized, there are no fitting arm guards. Since I did not rush my build and wanted to craft a quad, that pleases my aesthetics in every aspect it was no question to design my “own” arm…
These brushless motor mounts were designed for flying wings to attach common drone motors. There are three versions, differing in motor size. The mounts must be printed flat and then bent using a torch lighter.This requires some practice,…
This is a light shelf based on 9x9mm aluminum square pipe. All you need is a printer and some 9x9 pipes. To secure the shelves, holes for M3 bolts and nuts are built in in the three-way connector. The holes for 9x9 pipe are made bigger…
This is holder for OPAL 9x9mm garden faucet. In Finnish "vesiposti". This holder will be installed using three 2.5mm screws. Printed on 0.2mm layer size, no supports, PETG
