Polymaker / PolyTerra / Overture Cardboard Spool Adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A rebuild of the Polymaker spool adapter with enhancements designed to make improve lifetime while swapping spools.
- Rating
- 4.944 / 5
- Likes
- 106
- Downloads
- 973
- Makes
- 23
- Views
- 3,101
- Reviews
- 18
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- GNU General Public License v2.0
About
A ground-up rebuild of the excellent Polymaker spool adapter with the following changes:
- Edge clips removed (These tend to damage spools and are also not needed since the adapter uses the locator pin to lock into place)
- The Center design has been updated for a more generic spool look (More visually compatible with both Polymaker and Overture brands)
- The fitting has been slightly adjusted to allow easier swapping between spools without compromising its hold on the spool (less likely to break when being removed)
Printing
Prints well in PLA and PETG. PETG is less brittle and has better layer adhesion, which is beneficial with the very thin edges (to help avoid layer splitting).
Remixing
This model can be remixed using the provided Onshape link or via your own tools using the provided Step file.
Note for Open Sourcing 3D Printed models: If providing 3D models under an Open licence, please be genuinely #OpenSource, release your source files with your STLs and make it easier for others to collaborate. |