PCL XF Euro Air Hose Coupling
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Air hose coupling for use with PCL XF connectors. Standard 1/4 R BSP Thread Now also: M12 x 1 Fine for cheaper tools
- Rating
- 5 / 5
- Likes
- 43
- Downloads
- 254
- Makes
- 1
- Views
- 881
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I measured this from some connectors I had in use, print solid for strongest results. I have used some cheap PLA to produce these and I've tested the pressure up to 8.5Bar, but YMMV and I take no responsibility for injury caused by using these at pressure.
8mm of thread protruding, standard UK BSP R ¼ will fit most air tools. If there is any slight leakage, use PTFE tape to create a seal (this is common with metal fittings)
I have a few cheap air tools from ‘Ozito’ and they use a very unusual (for air tools) thread, M12x1, up until now I couldn't source a XF connector with this thread - well now you can print one. This model should be printed with the thread facing up
Designed to accept a 13mm spanner to tighten.
No supports were needed and printed thread facing down.